Downloads (daddelkischde 2)

Here you can find STL files for 3D printing to download.

3D models (STL)

You can download the following 3D models in STL format to print them on your 3D printer.

There are two variants of 3D models that are screwed together: One variant is intended for direct screwing. The screws grip directly into the plastic. This is cheaper, but does not endure many screwings. The second variant is intended for threaded inserts. These inserts can be melted into the plastic with a soldering iron and have the advantage that the screw finds a suitable thread and can be screwed as often as desired. The models are designed for M2 threaded inserts with a height of 3 mm.

Assembly helper

The assembly helper will hold the three PCBs and the Raspberry Piin place to easily solder them together.

Display cutout helper

The cutting helper makes it easier to cut out the display opening.

Shoulder button holder

This is the shoulder button holder that screws onto the shoulder button board. There is a variant for direct screwing and one for threaded inserts.

Display holder

The display holder is specially designed for the 3.5" DPI display and for the additional buttons on the front panel. The back case as well as the board are also screwed to the display holder. There are three variants:

• A one-piece version for fixed gluing of the display and for direct screwing into the plastic.
• A one-piece version for fixed gluing of the display, but for threaded inserts for screwing the back of the case and the board. There are three threaded inserts needed.
• A four-piece version, in which all parts are screwed with threaded inserts. Thus, the display can be changed later if necessary. There are seven threaded inserts needed.

Dummy artridge with air outlet

This special dummy cartridge contains an air outlet, so that the built-in air can blow the waste heat out of the housing.

Joystick drilling template

With this template, the hole for the joystick can be drilled at the appropriate location.

Micro USB cover

This cover is glued around the micro USB jack to prevent someone from looking inside the case.

DC barrel plug

This plug is used to close the unused DC barrel hole in the case.

Battery spacer

When using a narrow battery, this spacer prevents the battery from moving around inside the battery compartment.

Button shim

The button shims can be put between the buttons and conductive pads to improve the pressure point. There are two heights available.

Mode button support

A support for the mode button so that the force when the button is pressed is transferred to the case.

LED drilling template for cartridge

This drilling template helps you to drill parallel holes into the top of the cartridge for the LEDs.

JST extractor

With this small tool you can pull out the battery connector without having to pull on the wires.

Software

Here you can find software for the daddelkischde 2.

ZeroBOY OS 2

ZeroBOY OS 2 is a customized RetroPie image for the Raspberry Pi 2/3, which is already configured for the daddelkischde 2. You can find more details under configure.